Repotec GEL2P-ESW26G, Руководство по установке и началу работы

Страница: 26 / 35

Step2.
If the device is a network card and the switch is in the wiring closet, attach
the other end of the cable segment to a modular wall outlet that is
connected to the wiring closet. (See the section “ Network Wiring
Connections .”) Otherwise, attach the other end to an available port on the
switch.
Make sure each twisted pair cable does not exceed 100 meters (328 ft) in length.
N
OTE
:
Avoid using flow control on a port connected to a hub
unless it is actually required to solve a problem. Otherwise back
pressure jamming signals may degrade overall performance for
the segment attached to the hub.
Step3.
As each connection is made, the Link LED (on the switch) corresponding to
each port will light green (1000 Mbps) or amber (100 Mbps) to indicate
that the connection is valid.
NETWORK WIRING CONNECTIONS
Today, the punch-down block is an integral part of many of the newer equipment
racks. It is actually part of the patch panel. Instructions for making connections in
the wiring closet with this type of equipment follows.
Step1.
Attach one end of a patch cable to an available port on the switch, and the
other end to the patch panel.
Step2.
If not already in place, attach one end of a cable segment to the back of the
patch panel where the punch-down block is located, and the other end to
a modular wall outlet.
Step3.
Label the cables to simplify future troubleshooting. See “ Cable Labeling
and Connection Records ” .
.
Network Wiring Connections
Switch
Equipment Rack
(side view)
Patch Panel
Patch-Down Block
Wall
Revision A1
17