Step3.
Slide the SFP transceiver into the slot until it clicks into place.
N
OTE
:
SFP transceivers are not provided in the switch package.
CONNECTING
TO A POWER
SOURCE
You can plug or remove power cord from AC power socket , to
switch the power on and off .
Inserting the Power Cord to AC Power Socket
Step1.
Insert the power cable plug directly into the AC Socket located at the back of the
switch.
Step2.
Plug the other end of the cable into a grounded, 3-Pin, AC power source.
Step3.
Check the front-panel LEDs as the device is powered on to be sure the POWER
LED is lit. If not, check that the power cable is correctly plugged in.
W
ARNING
:
For International use, you may need to change the AC
line cord. You must use a line cord set that has been approved for
the socket type in your country.
CONNECTING
TO THE
CONSOLE PORT
The RJ-45 serial port on the switch’s front panel is used to
connect to the switch for out-of-band console configuration. The
command-line-driven configuration program can be accessed
from a terminal or a PC running a terminal emulation program.
The pin assignments used to connect to the serial port are
provided in the following table
Publication date: Sept. 2015
Revision A1
13
