2
1
Measure
Determination of the
diameter
Put the back on the edge
against the measuring scale.
Read the diameter of the
binding element (e.g. 3/8”)
2
Adjust
Scale for adjusting the
diameter
Release attachment screw,
determine scale, adjust
diameter, tighten attachment
screw
Adjust distance edge to
according diameter turn
knob
Turn knob index to the according
diameter (e.g. 3/8”) bigger 0 –
bigger edge.
Adjust format 11” Paper
guide right
Pull pins
Screw down the right paper guide,
pull 5 pins from left (21 loops).
Adjust format 8.5” Paper
guide left
Pull pins
Screw down the left paper guide,
pull 5 pins from left and 5 pins from
the right (16 loops).
3
Insert
Lay binding element in
front of the clamping
fixture
Small loops on top, facing
rear.
Press down clamping fixture
Press back edge and front side will
open.
Push binding element
under the clamping fixture.
Clamping fixture holds binding
element during insertion of the
punched paper.
Release clamping fixture
possibly adjust binding
element vertically.
4
Prepare
The seam of the closed
binding element should
be inside the book
Not outside the covers
Set the book upright,
binding side to the top,
place the back cover in front
The front cover should be behind
the back cover.
Jog the book
Turn the book over, covers
are underneath
Take pages from the t op
