Page 20 Twist-A-Mini
™
Manual
Setting up
Installing a bit in the Twist-A-Flex
™
Follow the steps below to install a bit in the Twist-A-Flex
™
rotary tool
attachment .
Part
Action
1
Insert the shaft locking pin (1) into the locking hole (2) in the
Twist-A-Flex
™
rotary tool head . This is to prevent the spindle
from turning .
Note:
Repeat when unfastening .
2
Rotate the collet nut (3) with your fingers until the locking pin
slips fully in place .
3
Loosen the collet nut .
4
Insert the bit (4) into the collet and tighten the collet nut with
the Ø 10mm (Ø 3/8”) collet wrench .
Note:
The Twist-A-Flex
™
rotary tool has a Ø 4 .76mm (Ø
3/16”) collet that will take all accessories with a Ø 4 .76mm
(Ø 3/16”) shank .
5
Rotate the collet by hand to make sure the installed bit does
not wobble .
(2) Locking Hole
(1) Shaft Locking Pin
(3) Collet Nut
(4) Bit
