Page 14 Twist-A-Mini
™
Manual
Setting up
Changing the collets
The bits for Twist-A-Mini
™
are secured with the collet nut and collet .
There are three sizes of collet depending on which bits you are attaching .
Note:
Ø is the symbol for ‘diameter’ .
Follow the steps below to change the collets on your Twist-A-Mini
™
.
Part
Action
1
Remove any bits from the Twist-A-Mini
™
if applicable . Refer
to
Installing bits
on page 16 .
2
Turn the collet nut (1) counter-clockwise and remove it from
the spindle (3) .
3
Remove the collet (2) from the spindle and insert the new
collet .
Note:
As each collet is the same on both ends, either end
can be inserted into the spindle .
4
Replace the collet nut and lightly tighten by hand .
Note:
Tightening the collet nut without a bit in the collet will
make the collet diameter smaller, which will make installing
bits difficult. Leave the collet nut loose when storing
Twist-A-Mini
™
with no bit installed .
Continued on next page…
