Owner‘s Manual Crimping Machine CM 25-1.3
Rev.: 2016-05-31
5 / 15
3. Transportation of Crimping Machine
Always avoid damages when loading and unloading the machine. All damages, which occur during transport,
are the responsibilities of the carrier.
After carefully removing the packaging, the machine must be inspected for
possible damages. Any discovered damages must be reported to the manufacturer
RENNSTEIG WERKZEUGE GmbH Viernau. Please note that certain machine settings
will be carried out later at the job site.
Attention
4. Limitations of Liability
The manufacturer will not assume any responsibility for the following damages occurring
because of:
• Failure to follow the operating instructions
• Improper use
• Use by non-trained and non-skilled personnel
• Unauthorized modifications of the machine
• Technical modifications
• Usage of spare parts, which are not approved by the manufacturer.
5. Requirements for Site-Set-up
• Minimum load capacity of work bench:
45 kg
• Total space requirement for the machine:
H x W x D = 500 x 500 x 300 mm
• Area for optimal operator performance:
1,5 m²
• Work bench height :
adjusted to the height of the operator
• Sufficient lighting:
needs to be provided.
•