Renkus-Heinz CF Series RHAON, Руководство пользователя

Страница: 37 / 56

Users Manual
37
AES/EBU Input Switch
When On, turns Analog 1 input
in to an AES/EBU input
Fault Relay
NO / NC relay contacts
used to report a failure to an
external monitoring system;
used mainly to trigger a failure
indication on a hard-wired
monitoring device; handles
up to 0.5 Amps at 24 V AC or
DC. Pin 4 normally open, Pin
5 swing blade, Pin 6 normally
closed.
Power LED
*ORZVZKHQDPSOL¿HU
power is On.
Primary Analog Input
XLR female
pin 1 chassis, pin 2 +,
pin 3 -.
Looping Analog Output
XLR female
pin 1 chassis, pin 2 +,
pin 3 -.
Signal LED
Flickers when an audi sig-
nal of at least -30 dBu is
present at the primary
analog audio input.
Overdrive LED
Flashes red when the
Primary Analog Input
SUHDPSOL¿HULVEHLQJ
overdriven.
Input Pad & LED Indicator
On / Off 10 dB pad for
Primary Analog Input;
allows input signals of
up to +24 dBu
when inserted.
Secondary Analog Input
Phoenix connector;
pin 1 +, pin 2 -,
pin 3 chassis.
Primary & Secondary
Ethernet Inputs
RJ-45 female
When both are con-
nected, changeover to
Secondary is automatic
if Primary fails. Yellow
/('ÀDVKHVZKHQWKH
connector is active, glows
steadily when data is
streaming. Green LEDs
glow when connected but
inactive, turn Orange to
indicate a faulty
connection.
Push Button Volume Controls
Also function as a manual
Standby/On control.
Mute Buttons
Turn loudspeaker
muting On & Off.
Thermal LED
Lights to indicate that an
over-temperature sensor has
VKXWGRZQWKHDPSOL¿HU
Protect LED
Lights to indicate
that protection
limiting is engaged.
Appendix III: RHAON Hardware Inputs, Outputs & Indicators, Dimensions
The RHAON input panel shown on the previous page is for a PF2-500R module; input panels for the PF1-200R and PF1-500R have the same
controls in different layouts. The PM3-R RHAON module also has the same controls and indicators as the PF2-500R, but in a different layout
VHHEHORZ
NOTE:
1. To prevent inadvertent operation the Mute, Volume Up & Volume Down, Input Pad and AES/EBU push buttons need to be pressed and
held down for several seconds before they activate.
2. To toggle between On and Standby manually, hold both the Up & Down Volume push buttons down for approximately 3 seconds.