Renkforce DJ-10, Руководство по эксплуатации

Страница: 27 / 74

27
(9) MIC connection
A dynamic microphone or a condenser microphone with its own power supply and a 6.3 mm jack plug can
be connected to this connection.
(10) Connection AUX IN
A playback device with line level (e.g. MP3 player) and 3.5 mm jack-plug connector can be connected to
this connection.
(11) PHONES connection
A stereo headphone can be connected to this 6.3 mm jack socket for pre-listening.
(12) Level indicator
The level indicator shows the output signal level visually.
Ensure that the output is not overloaded. The red level indicator LEDs should only flash briefly.
(13) POWER switch
The mixer is switched on or off using this switch.
Position ON:
Device on
Position OFF: Device off
(14) AC IN connection
The low-voltage plug of the mains unit is plugged in here.
(15) USB connection
Use this connection to connect a computer for recording or playback purposes.
(16) OUTPUT connection
A free input of your amplifier is connected here.
(17) LINE connections
The signal sources with line level (e.g. CD-player) are connected here.
(18) PHONO connections
The phono devices are connected here.
(19) GND terminal clamp
To prevent humming distortion, a ground connection can be established via this screw clamp between the
mixer and the ground line of the record player (usually black cable with clamp-type socket).
(20) LINE/PHONO switch
This switch specifies whether a line device or a record player is connected to channel 1.
Position LINE:
Connection for line devices (CD-player, tape decks, etc.)
Position PHONO: Connection for phono device (with magnetic system)
Always place the switch in the position intended for the device you have connected. Failure to do
so results in distortion, which could damage the mixer and the connected devices.