29
CONT
The CONT operating mode always takes precedence over the operating mode TIMER.
• Press the red CONT (11) button on the remote control.
• The device permanently emits fog. The red display LED above the CONT (11) button is lit.
• Set the desired fog quantity using the OUTPUT (8) controller.
• Adjust the fan speed with the WIND SET (9) controller.
• To deactivate this operating mode again, push the red CONT (11) button on the remote control again.
TIMER
• Push the yellow TIMER (10) button on the remote control.
• The device now emits fog controlled by the timer. The yellow display LED above the TIMER (10) button is
lit.
• Set the desired fog quantity using the OUTPUT (8) controller.
• Adjust the fan speed with the WIND SET (9) controller.
• Set the desired interval time using the INTERVAL (7) controller.
• The device will produce fog for the set time and then pause. Then the described interval starts over.
• To deactivate this operating mode again, push the yellow TIMER (10) button on the remote control
again.
DMX mode
For this operating mode, the DIP switch 10 must be in the OFF position and the green LED below
the DIP switches (1) must flash.
In this mode, the device cannot be operated via the remote control or right at the device.
• Every DMX device in a DMX chain requires an assigned DMX starting address to be clearly identified by
the controller.
• This DMX starting address is defined by the DIP switches 1-9 on the rear of the device. Each DIP
switch (1) is assigned a value. The total of these values then defines the assigned DMX starting
address.
• The values of the individual DIP switches 1-9 can be taken from the table below. If a switch is in the „ON“
position, it is activated, while in the „OFF“ position it is deactivated.
DIP switch
DMX channel
1
1
2
2
3
4
4
8
5
16
DIP switch
DMX channel
6
32
7
64
8
128
9
256