Renfert 29360000, Быстрый старт

Страница: 18 / 88

EN
Operation
Switching On
The suction unit is switched on and off via the on / off switch (3).
After activation:
♦ The suction unit performs an automatic filter cleaning sequence
(for approx. 8 seconds, loud vibrating noise).
Stand-by
In the stand-by mode the display is dark.
Leave stand-by mode:
• Press any button.
• Switch on any electrical appliance connected to the extractor.
Select vacuum channel
Start / stop suction turbine and open / close corresponding pinch valve valve:
• Automatically:
The electrical appliance connected to the device socket (8A / 8B) is activated /
deactivated.
• Manually:
By pressing a suction hose button (29).
If the suction to a connected electrical appliance (e.g. a handpiece) does not react as required
(e.g. does not activate, even though a connected device is in operation) then the switch-on
threshold for automatic operation must be adjusted.
Suction Power
⇒ Press the [-] key (31): Reduce suction
⇒ Press the [+] key (33): Increase suction
Setting the Parameter
On delivery, there are parameters set, which in most cases, make it possible to work with the suction unit
without problems. Only in individual cases, if this is not possible, the parameters can be changed.
The setting of various parameters and the execution of a self-diagnosis are carried out in the program-
ming mode.
Information on how to set the parameters and perform a self-diagnosis can be found in the oper-
ating instructions in the Internet or in Figs. D and E at the start of this manual.
The display indicates which parameters are set:
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
Perform self-diagnosis
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
/
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
Acoustic signal (buzzer) on / off
MENU
A B
OFF
ON
A
B
OFF ON resetdefault
Time interval for full display (full) in the dust drawer
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
Setting the automatic switch-on (calibration)
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
Set after-run (time) for the suction turbine
To set the different parameters, press the Menu key 20.
The settings are confirmed and saved with the Enter key 30.
Successful saving is acknowledged with an acoustic signal.
If a change is not accepted, pressing the Menu key (20) will abort the program-
ming.
If the word “Default” (32) appears in the display, you can reset the value to the
factory setting by pressing the [-] and [+] keys at the same time.
3
MENU
A B
OFF
ON
A
B
OFF ON
resetdefault
29
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
MENU
A B
OFF
ON
A B
OFF ON resetdefault
30 20
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
32
- 4 -