SMARC EVK of RZ/G2L, RZ/G2LC, RZ/G2UL, RZ/V2L, and RZ/Five
Start-up Guide
R01US0556EJ0102 Rev.1.02
Page 32 of 37
Jun. 17, 2022
After successfully download the binary, messages like below are shown on the terminal.
SAVE -FLASH.......
EM_W Complete!
Next, write another loader file by using EM_W command again.
>
EM_W
EM_W Start --------------
---------------------------------------------------------
Please select,eMMC Partition Area.
0:User Partition Area : 62160896 KBytes
eMMC Sector Cnt : H'0 - H'0768FFFF
1:Boot Partition 1 : 32256 KBytes
eMMC Sector Cnt : H'0 - H'0000FBFF
2:Boot Partition 2 : 32256 KBytes
eMMC Sector Cnt : H'0 - H'0000FBFF
---------------------------------------------------------
Select area(0-2)>
1
-- Boot Partition 1 Program -----------------------------
Please Input Start Address in sector :
100
Please Input Program Start Address :
0
Work RAM(H'50000000-H'50FFFFFF) Clear....
please send ! ('.' & CR stop load)
Send the data of “fip-smarc-rzv2l_pmic.srec” from terminal software after the message “please send !” is shown.
After successfully download the binary, messages like below are shown on the terminal.
SAVE -FLASH.......
EM_W Complete!
After writing two loader files normally, turn off the power of the board by changing the SW11.
Table 8. Address of EXT_CSD register of eMMC for eMMC boot
Address
Value to write
0xB1
0x02
0xB3
0x08
Table 9. Address for sending each loader binary file for eMMC boot
RZ/G2L Evaluation Board Kit PMIC version
File name
Partition to save to
eMMC
Address to save to
eMMC
Address to load to
RAM
bl2_bp-smarc-
rzg2l_pmic.srec
1
00000001
11E00
fip-smarc-rzg2l_pmic.srec
1
00000100
00000
RZ/G2LC Evaluation Board Kit
