SMARC EVK of RZ/G2L, RZ/G2LC, RZ/G2UL, RZ/V2L, and RZ/Five
Start-up Guide
R01US0556EJ0102 Rev.1.02
Page 21 of 37
Jun. 17, 2022
1.6
Setting U-boot
To set the board to SPI Boot mode, set the SW11 as below:
SW11
1
2
3
4
OFF
OFF
OFF
ON
Note:-
Set the SW1 on SoM module to eMMC mode. Please refer to the section 1.1.3.
Turn on the power of the board by pressing the reset button SW10.
U-Boot 2021.10 (Mar 31 2022 - 03:57:20 +0000)
CPU: Renesas Electronics K rev 14.15
Model: smarc-rzg2l
DRAM: 1.9 GiB
MMC: sd@11c00000: 0, sd@11c10000: 1
Loading Environment from MMC... OK
In: serial@1004b800
Out: serial@1004b800
Err: serial@1004b800
Net: eth0: ethernet@11c20000
Hit any key to stop autoboot: 0
=>
Following the messages above, many warning messages will be shown. These warnings are eliminated by setting
correct environment variables. Please set default value and save them to the Flash ROM.
=>
env default -a
## Resetting to default environment
=>
saveenv
Saving Environment to MMC... Writing to MMC(0)….OK
=>
