Renesas QB-RL78D1A2, Руководство пользователя

Страница: 18 / 41

QB-RL78D1A2 In-Circuit Emulator CHAPTER 2 SETUP PROCEDURE
R20UT3110EJ0101 Rev.1.01 Page 18 of 41
Nov 28, 2014
2.1 Software Settings
Check the user's manual for the debugger that will be used.
2.2 Clock Settings
The QB-RL78D1A2 clock must be set to the clock used by the target device. For details about how to set the clock,
check the user's manual for the debugger that will be used.
QB-RL78D1A2 clock settings for the clock used by the target device are shown below.
Oscillation with the resonator on the target system is not supported. Therefore, the in-circuit emulator cannot
emulate the oscillation operation of the clock on the target system.
Table 2-1. List of clock settings
Clock Used Clock Supply
(1) High-speed system clock
(X1 oscillator or External input)
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the
target system
(c) When the oscillator (OSC1) mounted onto the emulator
is used
(2) Internal high-speed
oscillation clock
Uses the clock internally generated from the emulator
(3) Internal low-speed
oscillation clock
Uses the clock internally generated from the emulator
(4) Subsystem clock
(XT1 oscillator or External
input)
(a) When the clock generated within the emulator is used
(b) When the clock (a square wave) is supplied from the
target system