tool kit ...................................................(up to the end of the DU)
hubcap tool ...........................................(up to the end of the DU)
jack .......................................................(up to the end of the DU)
wheelbrace ...........................................(up to the end of the DU)
towing hitch...........................................(up to the end of the DU)
wheelbrace ...........................................(up to the end of the DU)
puncture................................................(up to the end of the DU)
5.9
ENG_UD12590_2
Bloc-outils (X85 - B85 - C85 - S85 - K85 - Renault)
ENG_NU_853-3_BCSK85_Renault_5
End piece for special wheel
bolt
3
(depending on vehicle)
Towing hitch
4
Refer to the information on “Towing” in
Section 5.
Hubcap tool
5
or
6
This tool is used to remove the wheel
trims.
Jack
7
Remove jack
7
.
To refit, lower the jack fully and unscrew
it by one turn and pivot the base so that
it can be stored.
Storage compartment
1
(depending on vehicle)
This is for storing a lock nut.
Wheelbrace
2
This is used to tighten or release the
wheel bolts.
Tool kit
A
is located in the tray under
the luggage compartment carpet.
Depending on the vehicle, lift the cover,
then remove it.
Take out the tool kit, lifting it at both
ends.
To return it, proceed in the reverse
order to removal.
TOOL KIT
Tool kit (jack, wheelbrace, etc.)
1
A
7
2
3
4
5
6
Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the
tools are correctly clipped into the tool kit, then position it correctly in its housing: there is a risk of injury.
If wheel bolts are supplied in the tool kit, only use these bolts for the emergency spare wheel: refer to the label affixed
to the emergency spare wheel.
The jack is designed for wheel changing purposes only. Under no circumstances should it be used for carrying out repairs un-
derneath the vehicle or to gain access to the underside of the vehicle.