Remlinger 3500, Руководство пользователя и инструкции по установке

Страница: 9 / 58

Rolling Finisher - Assembly
Base / Axle Instructions (Diagram page 15)
1. The first step is to identify the proper parts to assemble this section of
the cart. Set the base on saw horses or similar supports.
Note: The axle ears face the front of the cart.
2. Attach the axle assembly to the base. Use the (2) axle hinge pins, 1”-14
slotted hex nuts, and 3/16” x 2” cotter pins to secure the axle to the
base. Secure the axle pins to the hinge ears with a 3/8”-16 x 1 1/4” hex
cap bolt with locknut.
Note: The ears on the lower wheel arms should be pointed to the front.
3. Pin the 3” x 8” cylinders onto the cart. Use the standard pins and clips
supplied with the cylinder. Open hydraulic ports on cylinders to relieve
pressure. Extend the cylinders out, pin to the ear and place the cylinder
locks over the cylinder rods. Use the 1/2” x 2 1/2” clevis pin and bow-tie
keeper clip to secure locks in place.
Note: The hydraulic ports on cylinders must face out.
4. Place the (4) hub and spindle assemblies on the wheel arms. Use the
1/2”-13 x 3” hex cap bolt with locknut to secure the spindle into the
spindle tube. Attach the four tire assemblies to the hubs using 6 hub
bolts.
5. Bolt the jack stand mount to the base. Use the (2) 5/8”-11 x 3 1/2” hex
cap bolt, (4) 1/2”-13 x 3 1/2” hex cap bolt, (2) back plates, lock washers
and nuts to secure assembly to the base. Bolt the 5000# jack stand to
the jack stand riser. Use a 5/8”-11 x 3 1/2” hex cap bolt and lock nut to
secure the jack stand to the riser. Use the 5/8” pin supplied with the jack
stand to pin the jack stand riser to the jack stand mount. Use the 1/4”-20
x 1 1/4” bolt, nut, lock washer, and flat washer to attach the chain to the
jack stand riser.
Note: Mount jack stand assembly right of center on base.
6. Flat Fold - Place the (2) wing stand mounts on the base. Use (1) 1/2”-
13 x 3 1/2” hex cap bolt, lock washer, and nut. The stands should be
placed so that they catch the ends of the wings.
Stack Fold - Place the short wing stand mount on the LH side of the
base. Use (1) 1/2”-13 x 3 1/2” hex cap bolt, lock washer, and nut. This
stand should be placed so that it catches the end of the LH wing. The
longer of the stands is for the RH stack fold wing. Bolt the stand to the
hole closed to the center of the “RF” Cart. Use (1) 3/4”-10 x 3 1/2” hex
cap bolt, locknut. Bolt the (2) supports to the stand and base using (2)
3/4”-10 x 3 1/2” hex cap bolts, locknuts.
Note: The wing stands on the stack-fold machines are not adjustable.
9