Remlinger 3500, Руководство пользователя и инструкции по установке

Страница: 6 / 58

Rolling Finisher - Maintaining
Adjusting the Clevis Height
Major – Remove the two 3/4”-10 x 6” hex cap bolts and pull the
telescoping hitch out and rotate 180°. Replace the 3/4” bolts and
tighten. The clevis will also have to be rotated.
Minor – Remove the two 3/4” hitch bolts and move the clevis up or down.
Replace the bolts.
Adjusting the Hitch Length
Loosen the two 3/4”-10 x 7” hex cap bolts and slide the telescoping hitch
in or out to the desired length. Replace the 3/4” bolts and tighten.
(The
proper hitch length is 1/2 of the leading implement width.)
Lubrication
Use SAE Multi Purpose Grease
1. Transport axle (2 locations) - Every 15 hours
Zerk located inside the upper part of the wheel arm at the
pivot pin.
2. Gage wheel axle - optional (2 locations) - Every 15 hours
Zerk located inside the upper part of the wheel arm at the
pivot pin.
3. Front and Rear Wing Hinge (4 locations) - Every 15hours
Zerk located on the wing side of the hinge.
4. Transport & gage wheel bearings - Once a year or 50 hours
Raise the tires off the ground and check for end play. To
eliminate, remove dust cap and cotter pin. Tighten slotted
nuts until there is noticeable resistance and back off one
slot. Replace cotter pin and dust cap.
5. Harrow attachments - refer to the proper section of this
manual.
6