REMKO GPM 15, Операция, Технология, Запасные части.

Страница: 39 / 48

39
Parameter PARAM K
For access to the PARAM K
parameter, press the key KM
(Menu) for approximately 8-10
seconds.
The display shows:
INFO REG ERR >>
K1 K2 K3 K4
Press key K4 >> the display shows:
LANG PAR PARK >>
K1 K2 K3 K4
Press key K3 (PARK); the display
shows:
<< PARAM K 1 >>
K1 K2 K3 K4
The value of the adjusted
parameter appears through key
K4 and the corresponding

arrows; K3 indicates the number of
parameters to be changed [PARM
K].
Call up the parameters from 1 to
21 with the keys K1 (back) and
K4 (forward); the values of the
adjusted PARAM K parameter can
be changed with + and – .
To leave the settings menu,
press the key KM (Menu) for
approximately 8-10 seconds.
If no key is pressed for
approximately 20 seconds, the
electronic temperature regulation
automatically leaves the settings
menu and returns to the operation
programme.
Parameters REG SAN and FLOW VL
The parameter "REG SAN" is the
modulation set point of the NTC1
sensor found on the rear side of
the unit;
"FLOW VL" is the value measured
by the sensor.
Adjustment of "REG SAN" (unit
sensor)
Press key KM (menu); the display
shows:
HTG SAN INFO >>
K1 K2 K3 K4
Press key K4; the display shows:
PROG REG TIME >>
K1 K2 K3 K4
By pressing the key K2 REG you
arrive at the temperature settings.
Continue with K4 until the
following appears on the display:
<< REG SAN >>
K1 K2 K3 K4
The set point appears through the
arrows above key K4.
Adjust the desired temperature
value with the keys + and – (e.g.
18 °C).
Then press key KM in order to
return to the output menu.
Display of the value of the NTC1
sensor [param. "FLOW VL"]
In order to display the temperature
measured by the sensor on the
rear side of the unit,
press key KM (Menu).
HTG SAN INFO >>
K1 K2 K3 K4
Press key K3 (INFO); continue with
key K4 (>>) until the following
appears on the display:
<< FLOW VL >>
K1 K2 K3 K4
The value that appears on the
display over the arrows above the
key K4 is the value that has been
measured by the NTC sensor
found on the rear side of the unit.
Display of output
In order to display the output
with which the unit is working in
percent, press key KM (Menu).
The display shows:
HTG SAN INFO >>
K1 K2 K3 K4
Press key K3 (INFO); continue with
key K4 (>>) until the following
appears on the display:
<< BURNER >>
K1 K2 K3 K4
The value on the display
corresponds to the output in %.
The reference values are:
Burner at min. output 0%,
Burner at max. output 100%.
These values have no connection
with the PWM value.
Fault display and reset
In case of malfunction, a flashing
triangle appears on the display
with the message:
RESET BOILER >>
K1 K2 K3 K4
By pressing the key K4 the type of
fault (from 1 to 4) is displayed.
Then press KM in order to arrive at
the fault display (flashing triangle).
Now press key K1 and the
malfunction is reset (the flashing
triangle disappears).
Parameter settings of the electronic temperature regulation