NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2015, Pinnacle Products International, Inc.
Kerosene Forced Air Heater User’s Manual
Assembly Instructions
Models: HH-125T-KFA / HH-175T-KFA / HH-215T-KFA
1. Insert axle through holes in wheel support.
2. Slide spacer onto axle.
3.
Slide wheel onto axle with the air valve facing
out and hold in place with the axle nuts. (See
Figure 5).
4. Place heater on wheel support and line up
holes on the fuel tank lip.
5. Attach front handle with (2) long screws
(50 mm) and (2) nuts through the second
hole from the front on both sides of the tank
lip and wheel support frame and tighten
firmly.
6.
Insert (2) short screws (30 mm) through the
first hole from the front in the tank lip and
tighten firmly. Make certain all (4) screws are
secure.
7. Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the third hole
from the rear of the heater on either side.
(See Figure 6)
8. Tilt the heater up gently so it is resting on the
front handle.
NOTE: DO NOT do this if there is fuel in the tank.
9. Remove the wheels to secure the second set
of screws through the rear handle.
10. Secure the rear handle with (2) short screws
(30 mm) and (2) nuts and tighten firmly
11. Replace wheels with the valve facing out and
tighten with the wheel nuts.
12. Tilt heater back down onto wheels and check
all screws and nuts to make sure they are
secure.
Figure 5
Axle
Axle Nut
Spacer
Tire
Wheel Support Frame
6
Tip: Do not tighten the nuts fully. You will
need to remove the wheels in a later step.
Tip: You will secure the back of the rear
handle in a later step by tilting the heater
up the front handle as shown in figure 7
Figure 6
Front Handle Rear Handle
Unused Hole
Wheel Support Frame
Tank Lip
Figure 7
1
2
