5
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little
at a time.
STEP 2 – Back of the head
With the comb set at 12mm or 18mm, cut the hair at the back of the head.
STEP 3 – Side of the head
Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to 9mm and continue to
cut the top of the head.
STEP 4 – Top of the head
• Use the large adjustable comb and set it to 24mm or 27mm then cut hair on top of the head
against the direction in which the hair normally grows.
• For longer hair on top, use the large adjustable comb (23 – 42mm) to achieve the desired
style.
• Always work from the back of the head.
STEP 5 – The finishing touches
• Use the clipper without an attachment comb for close trimming around the base and sides of
the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed
clipper at right angles to the head, tips of the blades lightly touching the skin and then work
downwards.
SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Starting with the longest guide comb attached (23 - 42mm), cut from the back of the neck
to the crown. Hold the guide comb flat against the head and slowly move the clipper through
the hair.
• Use the same procedure from the lower side to the upper side of the head. Then cut the hair
against the direction in which it grows and level with the sides.
• To give a “flat top” look, the hair on top of the head must be cut over the top of a flat comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
AUTO TURBO BOOST SYSTEM
• The Titanium Turbo Pro has 3 settings: Off, Auto & Turbo
• Press the on/off button once to turn hair clipper on. When switched on the hair clipper is
set to ‘Auto’ mode. In this mode the hair clipper will automatically detect when the hair
clipper requires more power to cut through thick hair and will activate Turbo mode to provide
maximum power.
• Turbo mode can also be permanently switched on, to activate the Turbo setting, press the
on/off button for 3 seconds. The clipper will then constantly run at maximum power. To turn
off Turbo mode, press the power button for 3 seconds.
CLEANING & MAINTENANCE
Your hair clipper is fitted with high quality Titanium Coated blades. To ensure long lasting
performance of your hair clipper, clean the blades and unit regularly.
NOTE:
Always remove the attachment guide comb from the hair clipper before storage .
AFTER EACH USE
• Ensure the hair clipper is switched off and disconnected from the mains before cleaning.
• Brush the accumulated hair from the blades. Do not submerge the hair clipper in water.
• To clean unit, wipe with damp cloth and dry immediately.