CLEANING & CARE
This shaver is a washable appliance.
The head assembly part may be cleaned under water.
NOTE: **When cleaning your shaver, make sure the shaver is
turned off and disconnected from the power cord.**
For optimal shaver performance, clean your shaver after each use.
CAUTION!
Shaver can be placed under running water for cleaning only. Never submerge
the shaver in water.
Never clean the shaver or replace the cutters while it is plugged into an
electrical outlet.
Do not remove or replace head assembly while shaver is running as it may
cause damage to the unit’s foils and cutters.
To clean the external surfaces of the shaver, use a damp cloth. Do not use
strong detergents or other chemicals.
To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
The shaver should not be used until it has dried.
Cover the shaver foils with the protective head guard between uses. When
removing the head guard or placing it back onto the shaver, do not apply
pressure to the foils as you may damage them.
Daily Cleaning:
1.
Release the cutter assembly by pushing the two release buttons and pulling the
hair pocket away from the shaver body.
2.
Tap the stubble from the foils and cutters.
3.
Use the cleaning brush to sweep any loose hairs from the cutters and trimmer.
Rinse them in cold or warm water. DO NOT use hot
water. DO NOT submerge the shaver in water.
4.
After cleaning, replace the hair pocket assembly.
Monthly Cleaning:
1.
Perform the daily cleaning steps 1-3.
2.
Place a drop of liquid soap on the inside near each
set of cutters.
9
