20
106088
Tool Disassembly and Assembly
4. Slide ejector spring (21) around within
retaining slot in breech (17) to free
ejector (16). Remove ejector. Inspect
ejector spring and remove only if dam-
aged.
ASSEMBLY
1. a.) Push piston (7) all the way into the
barrel (6).
2. Put ejector (16) into ejector slot in
breech (17), slide ejector spring (21)
over ejector. If new ejector spring is
used, carefully wind into retaining slot
in breech. Align spring so tapped hole
in slot is clear.
3. Press small end of breech spring (22)
onto shoulder of breech (17). Replace
breech spring and breech in receiver
(4). Slide barrel (6) in receiver and
align with ejector. Push barrel. Turn
CHECK FOR ANY DAMAGED PARTS.
CLEAN BEFORE REASSEMBLING.
7
6
b.) Place buffer (8), small end first, in
muzzle cap (5) and screw muzzle cap
into barrel (6).
16
21
17
Retaining Slot
5
6
8
16
Retaining Slot
21
17
Ejector Slot
4
17
22
18
19
20
482-90
6
4. With barrel (6) touching breech, insert
tang (3) and tang spring (2) into hole in
receiver making sure tang drops into
slot in barrel. Screw on tang cap (1)
completely. Be sure tang cap is always
kept tight, to ensure proper operation
of tang.
and align sear recess in breech with
sear access hole. Insert sear spring
(20) and sear (19). Flat with hole in
sear must face toward rear of receiver.
Twist breech to align sear with slot.
Replace set screw (18).
482-96
3
2
1
6
4
5. Assemble small end of firing pin spring
(14) on to end of firing pin (13). Position
firing pin and firing pin spring into rear
of receiver (4). Place receiver into
handle housing (12). Insert screw (9) in
front of trigger guard, but do not
tighten. Replace recoil pad (11) and
insert the two screws (10 and 15).
Tighten the upper screw (10) first, then
tighten the screw in front of the trigger
guard. Last, tighten up the lower screw
in the recoil pad.
13
14
12
11
10
15
9
482-97
4
