Remii WM-45-XS, Инструкция по установке и эксплуатации

Страница: 16 / 23

16
REMOTE CONTROL OPERATION
1. Press “ ”, the flame light
the brightest mode(Y4,O4,R4
heater is not working. Press
the display will disappear
fireplace.
2. Press “DISPLAY ON/OFF
display, twice to turn off the flame light, indicating
setting used on the fireplace.
3. Press “Yellow” to adjust
Y4-Y3-Y2-Y1-Y0, and Y0
4. Press “Orange” to adjust
O4-O3-O2-O1-O0, and O0
5. Press “Red” to adjust
R4-R3-R2-R1-R0, and R0
6. Press” TRAY LIGHT ON/OFF
display. Press again to turn off the tray light, indicating
flame light turns on, color yellow, color orange and color red are on
Y4,O4,R4), the tray light in white (E3), indicating
heater is not working. Press again to turn off the appliance, indicating
pear in 5 seconds. It will recall the last setting used on the
ISPLAY ON/OFF” once to turn on the flame light, indicating
display, twice to turn off the flame light, indicating “FO” on display.
setting used on the fireplace.
adjust the intensity of the yellow flame. There are 5 setting
and Y0 is when the yellow flame has turned off
adjust the intensity of the orange flame. T
and O0 is when the orange flame has turned off
adjust the intensity of the red flame. There are 5 setting
and R0 is when the red flame has turned off.
ON/OFF”, the tray light turns on in color white
lay. Press again to turn off the tray light, indicating”E0” on display.
, color yellow, color orange and color red are on
, the tray light in white (E3), indicating “ON” on display,
indicating “OF” on display,
t setting used on the
once to turn on the flame light, indicating “FF” on
display. It will recall the last
here are 5 settings,
has turned off.
There are 5 settings,
has turned off.
here are 5 settings,
, the tray light turns on in color white, indicating “E3” on
display.
For remote to function make sure the heater is plugged in and main power switch located on the
bottom left hand side is at position I.
When operating the remote make sure you point the remote to the centre of the fireplace and make
sure each time you press the button the buzzer inside the unit will beep once. It takes some time for
the receiver to respond to the transmitter. Do not PRESS the buttons more than once within two
seconds for correct operation.
HEATER ON/OFF
HIGH LOW TEMP.
YELLOW RED
DISPLAY ON/OFF
ORANGE
FLASH ADJUST
TRAY
ON/OFF