REMET CNC TECHNOLOGY SP. Z O.O.
Page 20 z 22
Manufacturer of machinery and equipment, CNC machining service
10.
MAINTENANCE AND CLEANING
Safety instructions for maintenance..
Before performing maintenance or repair, the device must be disconnected
from the power source and stand on a stable, level and non-slippery surface. The
device should be cleaned before and after each use, and the tightening of the cover
fixing screws must be checked.
General maintenance and cleaning activities
The device should be kept clean at all times. To clean the device, use only a
brush or a cloth. Never use any solvents or cleaning agents.
Check all covers and protective elements for damage and correct positioning.
Replace if necessary. Pay special attention to loose and worn parts. Check screws
and nuts are tight.
11.
DISPOSAL AND ENVIRONMENT PROTECTION
Dispose of the device, accessories and packaging in accordance with the envi-
ronmental protection requirements at specialized disposal points.
The device may not be disposed of as household waste. Save the environment.
The device should be taken to a local point of disposal. Utilization is free. Further
information can be obtained at the point of disposal. Incorrect disposal can be
punished according to local regulations.
12.
SOLUTIONS FOR SAMPLE PROBLEMS
Problem
Possible cause
Solution
The device does not pull
the branch
The cutting roller is blocked
Disconnect the drive, re-
move the blocking element
if possible
Cutting rollers rotate bac-
kwards
The propeller shaft turns
anti-clockwise (to the left)
to the right
Branches are not cut cor-
rectly
Blunt cutting knives or
damaged blade edges
Sharpen or replace if nec-
essary
Incorrectly arranged cut-
ting knives
Align the blades correctly
Metallic or other disturbing
sounds are heard during
work
Too much dirt inside the
mechanism or possible
bearing damage
After disconnecting the
drive source, clean the in-
side of the shredder.
If the bearing is damaged,
it must be replaced by
qualified personnel
