REMET CNC TECHNOLOGY SP. Z O.O.
Page 11 z 22
Manufacturer of machinery and equipment, CNC machining service
8.Before inserting the material to be cut into the inlet funnel, pay attention that
the material does not contain any foreign elements harder than wood, such as
stones, wires, ropes, nails, rivets, chains, etc., which may damage the knives,
cutting mechanism or the whole machine co as a consequence, it may lead to
a dangerous accident endangering the life and health of the operator and other
bystanders.
9. In the event of blockage of the chopping mechanism, stop the tractor engine
driving the chipper immediately.
10. If branches of the operator are caught on the clothes and pulled towards the
inlet of the chipper feeder, the tractor operator must immediately bring the tractor
to a halt.
11. To prevent accidental starting of the tractor engine driving the chipper, remove
the key from the ignition or disconnect the battery by removing the clamp from
the clamp.
12. During each break in work, the chipper drive must be switched off.
13. When the cutting system is working transportation, handling and lifting are
prohibited.
14. To avoid jams, insert limp and thin material alternately with larger branches.
15. Switch off the machine when all the material has passed through the shredder.
Otherwise, the device may jam.
16. Keep a safe distance from the machine during work, because long branches
can be thrown out during pulling.
Activities after finishing work.
1. After switching off the drive, wait a short while, as the rotating parts of the
mechanism run for some time after switching off the drive.
2. Make sure the machine is completely stopped and then perform the cleaning
and maintenance of the machine.
3. Park the machine and secure it in a parking place.
4. Inspection of the technical condition, adjustment and performance of ad hoc
repairs and maintenance works as well as cleaning of parts and working assemblies
may be carried out only when the chipper has the drive off.5. Periodically you
should check that all bolts and nuts are tight. Replace damaged ones.
6.
When replacing a damaged chipper knife, always tighten or unscrew the knife
with protective gloves and in accordance with the instructions in section 9.
