REMEHA remasol-2 200C-2S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 44

n
Connecting
CAUTION
Soft soldering is not authorized.
The use of flux promotes corrosion conditions in systems
operating with propylene glycol as heat transfer fluid. In all
cases the inside of the pipes must be flushed.
4
Use of a hacksaw is prohibited.
4
Pipe connections by compression fittings.
4
Hard soldering: Hard soldering: hard soldering filler metal without
flux in accordance with DIN EN 1044, e.g. L-Ag2P or L-CuP6.
4
Pipe fittings: can only be used if they are resistant to glycol,
pressure (6 bar) depending on version) and temperature (-30 °C,
180 °C) (manufacturer’s data).
4
Sealing material: Hemp.
4
Press fitting (6 bar, 140 °C).
4.8.2. Primary heating circuit
Before connection, rinse the primary circuit to evacuate any particles
that may damage certain devices (safety valve, pumps, valves, etc.).
4
Hydraulically isolate the primary and secondary circuits using stop
valves to facilitate maintenance operations on the unit. The valves
make it possible to carry out maintenance on the calorifer and its
components without draining the entire installation.
4
Carry out installation in compliance with the prevailing legislation
and standards.
4.8.3. Connecting the calorifer to the domestic
water circuit (secondary circuit)
When making the connections, it is imperative that the standards and
corresponding local directives are respected. To reduce heat losses
as much as possible, insulate the pipes.
Belgium:
Make the connections in accordance with Belgaqua
technical instructions.
n
Specific precautions
Before making the connection,
rinse the drinking water inlet
pipes
in order not to introduce metal or other particles into the
appliance’s tank.
n
Provision for Switzerland
Make the connections according to the instructions of the Société
Suisse de l’Industrie du Gaz et des Eaux. Comply with local
instructions from water distribution plants.
M001756-A
200...500C-2S 4. Installation
21/03/2016 - 7652081-001-02 22