REMdevice BRICK 09, Инструкция по эксплуатации

Страница: 19 / 37

Installation, start up and operating manual –
version 5.3 Gen.10
Radio control BRICK and PAIL
Wiring of the receiver unit RxDIN
For internal installation (on DIN bracket) to the machine’s electric panel.
The wiring of this model of receiver must only be carried out by
the manufacturer of the
electric panel.
If the electric panel is made from
metal place the active antenna on
the outside.
Use Ø 16 mm holes for fixing on
the desired side.
Use the cable inlet bolt to lock the
box into position. Figure 11.
Testing the radio control unit
For a RxDIN-CL receiver:
• with the machine to be operated turned off, plug in the receiver’s
multipolar cable in the place of the cabled keypad and make sure
it is locked with the appropriate hooks.
•
check that the connection cable between the receiver and the
machine does not get twisted or caught up in mechanical parts
during movement of the machine.
• open the sealed casing to see the led that shows the state of the
receiver.
Switch on the machine to be operated. Always staying in a safe position
out of the range of action, in the event of a wiring error the machine
could accidentally move when switched on.
Check that the ON led is continuously lit (see Fig. 6) indicating electric
current to the receiver module.
Check that the PLL led is flashing (see Fig. 6) indicating the receiver
module’s radio signal is in stand by.
Check the antenna’s SMA connector is tightened.
Switch on the transmitter unit (as shown on Page 5) and check the
continuous LINK led is lit on the receiver (see Fig. 6) indicating the
correct communication between the transmitter and receiver.
CABLE INLET
Ø 16 mm
Figure 11
External Antenna for RxDIN
REM
device
®
- ITALY
19