Page
8
of
12
5 Instruction For Use
•
Carefully unpack the appliance and remove all packaging materials.
•
Clean each part with warm water, mild dishwashing liquid and a sponge
then dry them carefully. Do Not immerse the electrical components or
base unit in water or liquid.
5.1 Set Up
•
After cleaning and thoroughly drying, place the Base Unit on a stable and
flat surface near a power point. (Do Not plug in yet). It is important for the
unit to be level to create the desired flowing effect.
•
Ensure the small silicon seal around the motor spindle is in place.
•
Locate the end of the auger with the triangular hole onto the triangular
motor spindle which protrudes out the bottom of the melting bowl and slide
on.
•
Place the tower over the auger and down onto the melting bowl ensuring
the three locating feet fit over the three locating pins and push all the way
down.
Caution
: Do not attempt to place the auger or tower on the base unit, or
remove from the base unit while the motor is turning or while the appliance
is plugged into the power point. Do Not Touch Moving Parts.
5.2 Operation
Important:
The Unit Must Be Level To Operate Properly.
•
Plug into the power point and switch on.
•
Make sure the appliance works by testing the motor function. To do this,
rotate the Selector Switch to position “I”. This should start the motor (and
auger) turning and the heater under the melting bowl to start to heat. The
red indicator light will also illuminate.
Rotating the Selector Switch to Position “II” will turn the motor (auger) off
but the heater will continue to heat so as to prevent the chocolate from
hardening when the Fountain effect is not required.
•
Rotate the Selector Switch back to the “O” position to turn Off both motor
(auger) and heater.