Reliable H PrePak, Инструкции по установке, эксплуатации, уходу и обслуживанию

Страница: 23 / 24

23.
Ordering Information:
Model H 1” (40 mm) PrePaK Part Number Code Key
15
15 = 1½” (40 mm)
PrePaK Assembly
0
1
2
0 = No Air Compressor
1 = 1/6 Hp (120 VAC @ 60 Hz)
Air Compressor
2 = 1/6 Hp (220 VAC @ 50 Hz)
Air Compressor
0
1
0 = No
Releasing/Control Panel
1 = Potter PFC-4410-RC
Releasing/Control Panel
Air Compressor
Voltage
Unit Size
Releasing/Control
Panel
Example: 15 - 1 - 1
1½” (40 mm) Model H PrePaK Assembly, 1/6 Hp Air Compressor Factory Wired to 120 VAC @ 60 Hz, and Potter PFC-
4410-RC Releasing/Control Panel.
SOLENOID VALVE INSPECTIONS, TESTS AND MAINTENANCE
WARNING: THE OWNER IS RESPONSIBLE FOR MAINTAINING THE FIRE PROTECTION SYSTEM IN PROPER
OPERATING CONDITION. ANY SYSTEM MAINTENANCE OR TESTING THAT INVOLVES PLACING A CONTROL
VALVE OR DETECTION SYSTEM OUT OF SERVICE MAY ELIMINATE THE FIRE PROTECTION OF THAT SYS-
TEM. PRIOR TO PROCEEDING, NOTIFY ALL AUTHORITIES HAVING JURISDICTION. CONSIDERATION SHOULD
BE GIVEN TO EMPLOYMENT OF A FIRE PATROL IN THE AFFECTED AREA.
WARNING: PRIOR TO OPERATING THE SOLENOID VALVE, BE SURE TO CLOSE THE SYSTEM CONTROL
VALVE TO AVOID UNINTENTIONAL OPERATION OF THE DELUGE VALVE
1. Inspections: It is imperative that the system be inspected and tested in accordance with NFPA 25 on a regular basis. The frequency
of the inspections may vary due to contaminated water supplies, corrosive water supplies, or corrosive atmospheres. In addition, the
alarm devices, detection systems, or other connected trim may require a more frequent schedule. Refer to the system description and
applicable codes for minimum requirements.
2. The valve must be inspected at least monthly for cracks, corrosion, leakage, etc., cleaned and replaced as necessary.
3. If leakage is suspected through the solenoid valve, it should be replaced.