Reliable BRIO PRO 1000CC, Инструкция по эксплуатации

Страница: 8 / 45

06
8. Positions 1 to 3 on the handle, are for steam only regulation (each one provides
twice the strength and pressure of the previous one).
9. Position 4 on the handle activates the hot water injection. This feature mixes steam
and hot water to produce a super strength cleaning jet.
10 During use, the green light (A) will alternatively turn on and off. This is normal, and
indicates that steam is being generated in the steam chamber.
11. To shut the unit off, turn the main power switch (1) to position 0. It is recommended
to unplug the unit when not in use. Allow to cool for approximately 30 minutes
before storage. Any water remaining in the steam generator can be left for 1 - 3
months. Never store the unit in an area where the temperature is below zero with-
out first draining the water from the tank, as damage may occur to the tank.
12. NOTE: We recommend to drain the tank when the boiler is cold. Take off the drain-
age cap at the bottom of the machine using a coin; completely unscrew the boiler
drainage plug using a 20 mm hexagonal key (19). After drainage, replace the nut
and the cap.
13. The frequency of the draining depends on the hardness of the water. Minimally, it
should be done every 1-3 months. For cleaning instructions, please refer to page 8.
THIS MODEl IS PROVIDED WITH THE
FOllOWINg FEATuRES
STEAM READy lIgHT (A)
A green light signals that the steam has reached the maximum working pressure and the
unit is ready to be used.
lOW WATER CONTROl lIgHT (B)
A red low water warning light signals that the water tank needs to be refilled. If you wish
to continue steam cleaning, unscrew the water tank cap (4) and refill the tank.
STEAM REgulATIONS lIgHTS AND HANDlE CONTROl
The two yellow lights signal the three possible regulations of steam quantity/strength.
The first steam regulation on-light (C) corresponds to the minimum steam quantity, posi-
tion 1 on the handle (G). The second regulation on- light (D) corresponds to a medium
steam quantity, position 2 on the handle (H). Both the first and second regulation on-
lights (C + D) correspond to the maximum steam quantity, position 3 on the handle (I).
HOT WATER INJECTION lIgHT AND HANDlE CONTROl
This yellow light signals the activation of the hot water Injection feature. When this light
(E) is on (position 4 on the handle (J), the steam is blended with hot water, making it
ideal for rinsing applications.