THERMOJET
®
G-3700E SERIES
OIL PURIFIER SYSTEM
INSTALLATION AND OPERATING MANUAL
Doc #
77740151
Rev
03
Date
June 2020
Page
30
of
111
Start-Up Procedures
Before each start-up, perform a “walk-around” of the purifier installation noting if the points
covered in INSTALLATION Section
of this manual are correct.
Ensure that the oil filter element is installed in the filter housing and that the O-ring is in good
condition.
If installed, open the oil supply block valve at the serviced oil reservoir.
Use the block valve on the bottom of the reservoir to drain any free water which may have
accumulated. Care should be taken to avoid spills and ground contamination with the drained
waste.
NOTICE:
When cleaning oil spills consult with your
lubricating oil supplier and the lubricating oil MSDS
documentation regarding safe guards and
Personal Protective Equipment (PPE)
requirements
In case of oil spillage, the user or other responsible
body must ensure appropriate cleanup and
decontamination is carried out.
NOTICE:
Dispose of all contaminated cleaning materials in
accordance with all environmental laws, ordinances
and directives. Consult your company or plant
environmental protection department for disposal
policy. Understand the environmental effect of any
used cleaning agents used and plan your cleanup
accordingly.
Use environmentally friendly products and recycle
where ever possible
