REL iREL Systems, Руководство пользователя

Страница: 10 / 48

www.relinc.com iREL Systems
9
•
System Restart
o
After ESTOP:
•
To restart the line after an ESTOP was pressed use the start zone ##
motors button in all the zones starting with zone 7 and counting
down
o
After Zone Fault:
•
To restart after a Zone fault start the zones that stopped from the
highest number to the lowest
o
During a startup sequence:
•
If a zone faults out during a startup sequence fix the fault and start
the faulted zone and the startup sequence will continue.
o
Zone 5 or Zone 6 Lock out:
•
If Zone 5 or 6 is locked out each of the servo motors will have to be
reset using the reset popup accessed by clicking on each servo.
Control Functions:
•
REMOTE/LOCAL Mode selection
o
This button is security protected, you have to be logged in to change it
o
During normal run the line will be in REMOTE mode
o
In REMOTE mode the line will be started/stopped from the main plant
DCS/Control System
o
In LOCAL mode the line can be started/stopped from the (2) local HMIs
•
A “START SYSTEM” button will be visible in Local mode
•
PRODUCT SIZE selection
o
This button is NOT security protected
o
This button selects the board size (4’ x 8’ or 4’ x 10’)
o
Note: The product size cannot be changed when the stop fence is down.
•
NO FLIP/FLIP selection
o
This button is NOT security protected
o
This changes the mode of the system to flip the boards or NOT flip the boards
o
In FLIP mode the button will be light gray and will read “PRESS FOR NO FLIP
MODE”
o
In NO FLIP mode the button will be dark gray and will read “PRESS FOR FLIP
MODE”