Rekluse RadiusX Clutch, Инструкция по установке и эксплуатации

Страница: 53 / 61

Doc ID: 191-6300B
Doc Rev: 101722
Pg. 23
BREAKING-IN THE NEW CLUTCH
Once you install your new clutch, it is important to break it in.
A series of roll-on starts are used to break in the clutch.
Follow these steps for breaking in your clutch and any time
new friction disks, EXP bases, Teflon pads, or wedges are
installed.
Failure to follow the break-in procedure and oil screen
inspection process could cause motor oil delivery
failure, which can result in motor failure, serious injury,
or death.
Break-in Procedure Number of times
Rev Cycles:
1. Place the bike or ATV in
NEUTRAL.
2. With your hand off the clutch
lever, rev the engine 10 times,
being sure to let it
return to idle
between each rev cycle.
10 rev cycles
3. With the engine still running, pull
in the clutch lever, then click the
bike/ATV into 1
st
gear. Slowly
release the clutch lever. The
bike/ATV should stay in place or
have a slight amount of forward
creep.
4. With the bike/ATV idling in first
gear, slowly apply throttle to
begin moving.
Continued on
next page