Reka TR 50.4 25, Руководство по эксплуатации продукта

Страница: 5 / 28

3
Safety Measures to be taken during
Operation
The applicator must only be used by trained, instructed and authorized persons. These persons must have read the operating
instructions and be able to work accordingly. Before using the applicator, check it for visible damage and make sure that it is only
used when in proper and safe condition. Notify detected defects to the appropriate person immediately.
Safety Instructions for the Operation of the Hot­Melt Applicator
Only fill the tank up to 1.5 cm under the upper rim.
Never exceed the operating temperature of the hot melt.
This temperature is indicated in the technical
specification of the glue. Overheating may lead to
decomposition which may affect the health of the user as
well as the operability of the applicator.
Once the glue applicator has warmed up, nozzle and
lid are very hot.
Do not start working before fitting a nozzle first.
Only replace nozzle when applicator is warm.
Unplug the connecting cable before replacing a
nozzle. Warning: risk of burns! When a nozzle is
replaced, liquid glue might leak out.
Never bring the hot nozzle into contact with the cable.
Never direct the glue jet towards people.
Wear protective gloves and safety
goggles whenever you work with the
applicator.
Avoid accidents by stumbling – Lay all
cables, hoses and conducts so that they
will not cause any risk of stumbling. For
this, install cable ducts and bridges.
When your skin got into contact with hot
glue, cool it with cold water immediately.
Do not try to remove the hot­melt from the
skin first. If necessary, consult a doctor.
When hot adhesive got into your eyes,
immediately cool them under running
water for about 15 minutes and consult
your doctor at once.
Always deposit the glue applicator on the wire stand or
the respective plate destined for this purpose.
Do not lay the applicator on its side.
Never hold nozzle top upward. Otherwise hot­melt may
reach the lid. This causes the venting mechanism to get
clogged or also lets hot­melt leak out of the applicator
when the lid is opened.
Do not carry out overhead work.
Stop using the equipment, if the casing is damaged
due to shock, breakage or heavy wear.
Do not feed solvents or paraffin. Risk of explosion!