S-AGR08-Egb08
05/15 - 3
Page 6 of 15
8 Maintenance
8.4
Reassembly of the automatic gun
1. Lay out all components and the required tools
on a clean level surface.
2. Mount the spray head (8) into the greased
standard needle set (9) with 0.8 Nm or mount
the special package made in stainless steel
with Kalrez o-rings into the spray head (8) and
tighten with a suitable tool with 3.0 Nm.
3. Wet gaskets (6) with little fat and put it in the
air distribution ring (7).
Attention: The gaskets are different. The
smaller diameter is in the air distributing
ring.
Too much grease can be carried away by
the fan air and atomizing air and reflected
in painting/coating on the workpiece.
That the gaskets do not slip, it makes sense
to hold the gun with the needle down vertically
and insert the air distribution ring with the gas-
kets from below.
Attention: Risk of injury!
Needle can be very sharp.
