Reikel AG2216, Руководство пользователя

Страница: 4 / 71

4
Original Instructions
Angle Grinder
5) Service
replacement parts. This will ensure that the
safety of the power tool is maintained.
EXTRA SAFETY REGULATIONS
CONCERNING THE ANGLE GRINDER:
Safety Warnings Common for Grinding
Operations:
a grinder. Read all safety
instructions, illustrations and specifications
Failure to follow all instructions listed below
serious injury.
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
marked on the power tool. Accessories
running faster than their rated speed can
your accessory must be within the capacity
rating of your power tool. Incorrectly sized
or controlled.
backing pads or any other accessory must
Accessories with arbour holes that do
not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load speed
for one minute. Damaged accessories will
normally break apart during this test time.
Depending on application, use face shield,
safety goggles or safety glasses. Where
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
generated by various operations. The
dust mask or respirator must be capable
operation. Prolonged exposure to high
intensity noise may cause hearing loss.
the work area. Anyone entering the work
area must wear personal protective
injury beyond immediate area of operation.
warnings,
Operations such as cutting off, sanding,
wire brushing or polishing are not
recommended to be performed with this
power tool. Operations for which the power
tool was not designed may create a hazard
and cause personal injury.