Code
Information
1b
Cycles
2b
Full charge % Cap
3b
Remaining % Cap
4b
Battery Voltage see below
5b …etc
Cell voltages (displays
available but no data.)
Approximate capacity by voltage (generic 36V L-ion battery)
Charge %
Volts
Charge %
Volts
100
42.0
50
36.0
95
41.4
45
35.4
90
40.8
40
34.8
85
40.2
35
34.2
80
39.6
30
33.6
75
39.0
25
33.0
70
38.4
20
32.4
65
37.8
15
21.8
60
37.2
10
31.2
55
36.6
5
30.6
Software version (St2)
From the St2 display, press the
[POWER]
button to display the current software
version. This may be useful if service is required.
Press
[POWER]
to exit this mode.
Photosensitive threshold setting (St3)
NOTE: If no headlight is installed this function is redundant.
Adjust this parameter to adjust the sensitivity of the automatic headlight function to
ambient light. The higher the value is, the lower the sensitivity is.
From the St3 display, press the
[POWER]
button to enter the Photosensitive
threshold setting mode.
Short press
[+]
or
[
‐
]
to change the photosensitivity levels.
Press
[POWER]
to save the change and exit
LIGHT NOTES:
There is no light installed on the E-Trail 2.0, but there is a connector under the plastic motor
housing for a light connection. Unfortunately, there is no cable running through the frame to
allow easy connection of a light, and you would need to run a cable externally along the
frame to use it.
