Settings
Note that the settings available are limited compared with other versions of the D10 display, as
the firmware enforces the 25km/hr speed limit imposed by Australian E-bike regulations
Basic settings
With the bike stationary, turn on the display press and hold both the
[+]
and
[-]
buttons.
Press
[+]
or
[
–
]
to cycle between:
•
Backlight brightness (1-3)
•
Units (km/miles)
•
Speed limit (from 12-25km/hr, 7.5-15.5mph)
Press
[POWER]
to adjust each setting when selected, use
[+]
or
[-]
buttons to change setting,
press
[POWER]
to end and save the setting
Advanced Settings Menu
In Basic Settings, press and hold both the
[+]
and
[-]
buttons
When you get the
“
PSd
”
prompt to
enter “
6262
”.
Use the
[+]
or
[-]
buttons change digits up and down, and the
[POWER]
button to select the next digit.
short press
[+]
button to switch between:
•
Battery information (St1)
•
Software version (St 2)
•
Photosensitive threshold (St 3)
Press
[POWER]
to adjust/display each setting when selected, use
[+]
or
[-]
buttons to change
setting, press
[POWER]
to end and save the setting
Battery Information (St 1)
(Note: Battery voltage should always be measured with the bike stationary.)
From the St1 display, short press
[POWER]
button to enter battery information
mode.
In this mode, short press
[+]
or
[
‐
]
to switch between the different battery displays.
Press
[POWER]
button again to exit battery information mode.
