Reichhardt GREEN FIT, Оригинальное руководство оператора, Страница: 26 / 32

PAGE 22
Error-No. Level Description Cause Troubleshooting
1010 0 No signal from 2nd angle
sensor.
- Short circuit in cable.
- Open wire in cable.
- Sensor is defective.
- Contacts of connectors are ope-
ned.
- Inspect 2nd angle sensor.
- Check cables from GREEN FIT Con-
troller to wheel angle sensor.
- If all connections are good, replace
wheel angle sensor.
- Check contacts of connectors.
1020 13 cabin door is open - cabin door is open
- open wire in cable
- door switch is defective
- contacts of connectors are ope-
ned
- close cabin door
- check cables from GREEN FIT Con-
troller to door switches
- check door switches
- check contacts of connectors
1021 13 Safety Switch error Safety Switch state is in error. Contact Reichhardt support.
1040 12 Pressure sensor – open wire - Pressure sensor is defective.
- Open wire in cable.
- Bolted connection of pressure
sensor is not correct.
- Contacts of connectors are ope-
ned.
- Pressure sensor is defective.
- Open wire in cable.
- Bolted connection of pressure sen-
sor is not correct.
- Contacts of connectors are opened.
1041 12 Pressure sensor – short circuit - Pressure sensor is defective.
- Short circuit in cable.
- Bolted connection of pressure
sensor is not correct.
- Contacts of connectors are clo-
sed.
- Inspect pressure sensor.
- Check cables from GREEN FIT Con-
troller to pressure sensor.
- Check bolted connection of pressu-
re sensor.
- Check contacts of connectors.
1042 12 Steering wheel was not turned. Since last disengaging steering
wheel was not turned.
Turn steering wheel, release and re-
engage.
1350 23 speed is too fast vehicle speed is too fast reduce speed and activate system
again
1351 23 no speed information from
„ISO GBSD“
tractor ECU doesn‘t support this
speed message
change setting of speed signal source
1352 23 no speed information from
„ISO WBSD“
tractor ECU doesn‘t support this
speed message
change setting of speed signal source
1353 23 invalid speed information - source of speed information is
invalid
- no messages received from sour-
ce of speed
change setting of speed signal source
1354 23 constant speed is active for testing, constant speed is
activated
WARNING
Risk of injury!
Once the steering system is
engaged, the axle is driven and
the wheels can move. Ensure
that no persons are in the
danger zone and drive with the
utmost care.
- change setting
- contact Reichhardt support
1355 23 speed too high for
engaging
current speed is too high reduce speed for engagement