Rehau RAUTOOL G2, Инструкция по эксплуатации / Техническая информация, Страница: 27 / 68

27
en
failure to observe these instructions may result in damage to the jointing system, to the tool and in personal injury .
1. Using pipe cutters, cut pipe to required length at right angles and without
leaving burrs. Do not use saws, or similar!
2. Slide compression sleeve onto pipe.
Caution:
On metal compression sleeves, the inner chamfer must point towards the
joint.
3. Expand pipe, rotate 30°, and repeat. The compression sleeve must not
be in the expansion area. Expansion is to be carried out using the pressure
switch or by activating the foot lever.
RAUTOOL G2
AsseMBLY pROcedURe
4. Insert fitting into pipe up to the stop. After a brief period the fitting will sit
tightly in the pipe (memory effect).
Caution:
All sealing ribs must be covered! Until the memory effect has fully set in, the
fixing can still fall out of the pipe. Make sure the fitting is positioned evenly.