15
RAUTOOL A-LIGHT2
TROUBLESHOOTING
Defect
Cause
Correction
Motor does not run
- Tool/battery contacts dirty
Clean contacts when dry with non-conducting material
- Tool/battery contacts damaged
Send tool/battery to your local REHAU representative
- Battery not correctly locked into the tool
Reinsert battery, pay attention to locking mechanism
- Battery empty
Charge battery
- Battery faulty
Give battery to the recycling system
- Tool faulty
Send tool to your local REHAU representative
Tool leaking oil
- Leak in oil tank or release valve
Do not open the tool and do not remove or damage
the tool seal; send tool to your local REHAU representative
Tool does not reach
- Leak in oil tank or release valve
Do not open the tool and do not remove or damage
final pressure
the tool seal; send tool to your local REHAU representative
- Air in the hydraulic system
Interrupt the compression process
Hold reset knob under tension (see page 6/no. 2) and at
the same time continuously activate the operating switch
for about 10 sec. If this does not correct the defect, the tool
must be sent to your local REHAU representative.
- Tool faulty
Return tool to your local REHAU representative
Battery does not
charge
- Charger not plugged in correctly
Reinsert mains plug
- No power coming to socket
Change socket
- Charger/mains cable or plug damaged
Send charger your local REHAU representative
- Charger not ready
Wait for green LED to flash
- Charger/battery contacts dirty
Clean contacts when dry with non-conducting material
- Charger/battery contacts damaged
Send charger/battery to your local REHAU representative
- Battery not locked correctly into the charger
Reinsert battery, paying close attention to locking mechanism
If the defects cannot be remedied, send the tool to your local REHAU representative .
