REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 5
FRONT HEIGHT 2
Fork support positioning
SERVICE MANUAL
For the model Exelle Junior, you can adjust the front height by moving the clamp
A
of the fork sup-
port and fix it to the holes on the frame.
These same holes are designed to fix the footplate positioning lever, too. In some case, as you will
see, the footplate support is involved in the front height adjustment.
Remember that the front height adjustment can affect the seat inclination, so it is necessary to
check and adjust the fork angle.
Adjustment of the fork support independently from the footplate positioning lever.
Screw off the bolts/washer/nuts
B C
.
Remove the spacing buckle
D
present on each fixing point. To remove the spacing buckle
D
you may
need to gently use a hammer and a pin punch.
Position the clamp
A
to the desired height following the holes on the frame.
If the clamp
A
results hard to move, loosen the nuts
E
.
Align the holes of the clamp to those on the frame and insert the spacing buckle
D
.
Once you have positioned the clamp, tighten the bolts
F
first, hold them and then tighten the nuts
E
.
The bots/washer/nuts
B C
should be tighten just enough to prevent a possible play of the clamp.
DO NOT TIGHTEN THEM TOO MUCH
because the flat face of the clamp may crack.
Adjustment envolving the footplate positioning lever
The adjustment envolves the footplate positioning lever when this lever is fixed to one or both holes on the frame where you need to fix the
clamp of the fork support and you want to keep the same footplate distance.
With “L
-
shape” footplate positioning lever (from 2018)
This “L
-
shaped” ambidextrous lever always allows for 1.5 cm adjustment without using the holes through which the fork support cl
amp is
fixed. In fact, you can orientate the lever in four directions and you can fix it using any to near holes.
E
B C
D
A
F
Follows next page
1.5 cm
G1
G2
G3
G4
G5
