REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual EXELLE JUNIOR 39
SERVICE MANUAL
BACKREST HEIGHT
Dynamic (first version) and Dynamic 2.0 rear frame
A
B
C
I
Dynamic 2.0
I I
Dynamic
I
B
m
in
. 4
c
m
Remove the backrest upholstery and slide up the protecting sleeves of the backrest bands along the
tube until the fixing screw A is accessible .
If it was not accessible:
- Dynamic 2.0 rear frame, partly fold the crossbar, remove the bolt/washer/nut
B
and turn the side
guard backward;
- Dynamic rear frame, loosen the two headless bolts
C
and the nut tha fixes the axle
P
(see also “
side
guard adjustment with rotative system
”) and turn the side guard frontward as much as necessary.
Remove bolt/washer/nut
A.
Raise or lower the backrest tubes to the desired height.
If the minimum height you can reach is not enough, it is necessary to cut the lower side of the tube.
If the maximum height you can reach is not enough, it is necessary to change the tube.
Warning
: to guarantee a good stability, between the fixing hole and the lower side of the tube, there
should be at least 4 cm. If the tube is cut, the lower hole will be only a few millimetres front the end of
the tube; therefore, you should not use that hole, the next and, sometimes even the third to fix the
backrest height.
Replace the screws and tighten.
Finally:
- Dynamic 2.0 rear frame, fix the side guard with the bolt/washer/nut
B
;
- Dynamic rear frame, turn the side guard to the correct position and then tighten the nut that fixes the
axle
P
and the two headless bolts
C
.
To reduce possible play and possible noise, you can put some sticky tape around the inner tube at its
bottom and at its fixing point (or just under it).
