www.vintage-mobility.ch
43
A2. DISAS ASSEMBLY
DISASSEMBLY
You can disassemble the scooter into several pieces: the seat, the main section, the rear
shroud, the battery shroud and the batteries.
No tools are required to disassemble or assemble your scooter, but keep in mind
that the disassembled sections of the scooter take up more floor space than the assembled
unit. Always disassemble or assemble your scooter on a level, dry surface with sufficient
room for you to work and move around your scooter
– about 2 meters (6.6 feet) in all
directions. Remember that some scooter components are heavy and you may
need
assistance when lifting them.
WARNING! Do not lift beyond your physical capability. Ask for assistance when
necessary while disassembling or assembling your scooter.
STEPS TO DISASSEMBLE THE GATSBY SCOOTER:
1. Remove the seat by lifting it straight up and off of the scooter. If you encounter resistance
when removing the seat, disengage the seat rotation lever and swivel the seat back and
forth while lifting up on the seat (See picture below).
3. Remove the battery shroud.
3. Gently pull the battery shroud up and off of the scooter.
4. Disconnect the battery tie-down strap.
5. Unplug both battery harnesses by pulling each harness out of its mating plug.
(See picture below).
6. Remove the batteries from the battery wells.
Figure 23: Disassembly of batteries and the seat post
Seat post
Battery tie down straps
Battery harness
