9 of 30
ISSUED: 07-12-06 SHEET #: 095-9234-10 08-23-07
Adjust tension knob on side of mount shown in figure
4.1 to desired tension to balance your screen size
and weight.
Push or pull from top or bottom of screen to adjust
tilt as shown. The tilt can be adjusted to a maximum
of 15° forward or 5° backward.
4
• Be careful not to pinch fingers when opening and
closing mount from the wall.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
TENSION KNOB
fig. 4.1
To attach screen to wall mount (A), lower hook
bracket (M) with screen at an angle into pockets of
wall mount as shown in figure 3.1. Once clips are
engaged, push down to seat clips in pockets as
shown in figure 3.2. Insert and tighten M5 phillips
screw (K) to lock screen to wall mount as shown in
figure 3.3.
To remove screen from mount, loosen screw (K) and
lift screen off of mount.
Installing and Removing Flat Panel Screen
3
4-1
Roll screen to desired position (5° clockwise or
counter-clockwise). Insert #10-32 x 1/4" flat head
phillips screw (O) to lock screen into position as
shown in figure 4.2.
fig. 4.2
O
M
SCREEN
K
A
fig. 3.1
fig. 3.2
fig. 3.3
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.
CAUTION
• Do not lift more weight than you can handle. Use
additional man power or mechanical lifting equipment
to safely handle placement of the screen.
• Failure to lock hook bracket (M) with screw (K) can
cause screen to come off mount if hit accidentally.
WARNING
CLIP
