Reggiani SPLYT Series, Руководство по установке

Страница: 13 / 57

www. reggiani.net
0 13
SPLYT | ENG |
mi-
m.
the
at
in-
wer,
eral
hen
zel
ide
the
ble.
aire
or-
nts
re-
ro-
in
force.
Unless the Reggiani S.p.A. Illuminazione
engineering department issues specifi c
authorisation, use of other drivers is pro-
hibited.
First connect the LED to the DRIVER, then
connect the DRIVER to the mains pow-
er supply. Do not connect the LED to the
DRIVER when the DRIVER is plugged into
the power supply because this could cause
of permanent damage to the LED.
Z-CONNECTION
The wiring between the LED and the DRIV-
ER is a Z-connection, so the fl exible cable
of this luminaire cannot be replaced. If the
cable is damaged, the luminaire must be
returned to the manufacturer.
DIMMING
There are four control gear options:
ON/OFF
PHASE CUT DIMMER
The driver can be dimmed on the mains
power by using a phase cut dimmer
(adopting MOS technology), adequately
rated (minimum 1W for each light point) to
provide 10% to 100% dimming.
ANALOGUE DIMMER (1-10V)
The driver can be used to dim the luminous
fl ux, drawing on a 0-10V direct voltage sig-
nal, transmitted by a twisted pair cable that
must be correctly wired to the positive (D+)
and negative (D-) pole. When connecting
it is necessary to follow the control device
manufacturer’s instructions.
DALI DIGITAL DIMMER
The luminous fl ux is dimmed by sending a
digital signal through a twisted pair cable
that must be correctly wired to the positive
(D+) and negative (D-).
When connecting it is necessary to follow
the control device manufacturer’s instruc-
tions.
EMERGENCY LIGHTING (for the semi-re-
cessed with bezel and trimless versions
only):
The luminaire in question can easily be
turned into maintained emergency lighting
(ALWAYS ON), by combining it with the ap-
propriate accessory: 35074 SPLYT for emer-
gency lighting (version: 15/32W 220/240V
50/60Hz) with 1h-3h back-up. For wiring,
follow the instructions enclosed with the
accessory.
PREPARATION AND
ASSEMBLY OF THE
LUMINAIRES
To assemble the luminaire,
turn the electricity off at
the mains and follow the
instructions below.
TRACK MOUNTED LUMINAIRES
The SPLYT track mounted family consists
of luminaires ready for mounting on the
Reggiani 3-circuit electrifi ed tracks.
Luminaires completes with adapter for
mounting on Reggiani 3-circuit track.
[The compatibility of the adapter with dif-
ferent tracks available on the market re-
quire verifi cation in advance].
To engage the adapter to the Reggiani
3-circuit track: make sure the adapter
is facing the right way when inserting it
I.M._Splyt_1.95415.indd 13 I.M._Splyt_1.95415.indd 13 01/08/16 08:55 01/08/16 08:55