www.
reggiani.net
0
12
ww
SP
SPLYT
|
ENG
|
GENERAL FEATURES OF
SPLYT
The SPLYT product line comes in two cat-
egories, depending on the size of the lu-
minaires: – 120 mm (9 LED) and 150 mm
(16 LED) – and in fi ve installation confi gu-
rations: track-mounted, surface-mounted,
semi-recessed with bezel (wall mounted),
trimless semi-recessed and semi-re-
cessed with bezel.
SPLYT conforms to directives:
• LV 2006/95/EC
• EMC 2004/108/EC
• WEEE 2002/96/EC
• RoHS 2011/65/EC
• Ecodesign 2009/125/EC
and safety standards:
• EN 60598-1
• EN 60598-2-1
• EN 60598-2-2
• EN 60598-2-22.
For more technical information about the
product (photometric, electrical data, size,
weight, certifi cation, accessories) refer to
the catalogue or see the product datasheet
on the website:
www.reggiani.net/reference.
ASSEMBLY INSTRUCTIONS
FOR SPLYT
The SPLYT family consists of ready-to-
mount luminaires for the track-mounted
and surface-mounted versions, or lumi-
naires that require cut-outs for the ceil-
ing-mounted and wall-mounted recessed
versions.
WARNINGS
Before assembling the luminaire, carefully
read these instructions to make sure the
luminaire functions correctly and safely.
Keep the instructions in a safe place for fu-
ture consultation; contact your supplier for
any problems that may arise.
The luminaire must not be modifi ed. Mod-
ifying the luminaire in any way invalidates
the guarantee of conformity with standards
and directives in force and it could make the
actual luminaire hazardous.
Reggiani S.p.A. Illuminazione shall not be
held liable for any damage caused by one of
its luminaires if not assembled in conform-
ity to the following instructions.
The luminaire must be installed in accord-
ance with the best working standards.
Before connecting the luminaire, make sure
the mains power supply corresponds to the
power indicated on the luminaire label.
The electrical installation the luminaire is
connected to must be wired in conformity to
the laws in force.
As a safety guarantee, any components
damaged while operating must be replaced
with the same components before the lumi-
naire is used again.
The minimum distance between the lumi-
naire and the lighted object must be 0.5m.
Never cover the luminaire during use.
Never use abrasives or solvents to clean the
luminaire.
Turn the electricity off at
the mains and follow the in-
structions below.
When wiring the driver to the mains power,
only use the wires indicated in the General
Notes. Use the electrical connectors when
supplied.
Caution (for the semi-recessed with bezel
and trimless versions only):
the driver must be positioned alongside
the luminaire, at least as far away as the
length of the driver-spotlight power cable.
The driver supplied with the LED luminaire
is specially designed to maximise perfor-
mance. It conforms to safety requirements
(IEC 61347), and performance require-
ments (IEC 62384), as well as to electro-
magnetic compatibility requirements in
forc
Un
eng
aut
hib
Firs
con
er
DR
the
of p
Z-C
The
ER
of t
cab
retu
DIM
The
ON
PHA
The
pow
(ad
rate
pro
AN
The
fl ux
I.M._Splyt_1.95415.indd 12
I.M._Splyt_1.95415.indd 12
01/08/16 08:55
01/08/16 08:55
