27
UK
Conformity:
European standards EN 60598-1, EN 60598-2-1, EN 60598-2-2.
Community Directives LV 73/23, EMC 89/336 and CEE 93/68.
IP 20
Degree of protection.
Direct mounting on normally inflammable surfaces.
Never cover the luminaire with insulating material and do not recess it.
0,8m
Minimum distance from the object to be illuminated.
The safety shields must be replaced in case of damage.
The luminaires must not be turned on without the safety shields.
Luminaires in Class I.
Connect the yellow/green earth wire.
Self-ballasting lamps do not require safety shields.
Use UV-Stop lamps only.
For cabling to the mains power supply,
use H05V2V2 multi-pole cable with wires of a cross section between 1,5 mm2 and 2.5 mm2.
Emergency luminaires.
- the preferential line must never be interrupted;
- luminous flux in emergency use: after 60 seconds, about 20% of the luminous flux of the bulb in ordinary operation;
Attention
: Keep these instructions carefully for future consultation.
Modifying the luminaire in any way invalidates the guarantee of conformity with current standards and directives.
The symbol indicates that the luminaire is subject to a voltage surge of 4.5 kV when the lamp is
turned on. Great attention must therefore be paid when installing the luminaire and when
replacing the lamp to avoid all risks from the supply voltage.
Connections of type Y. Flexible cable outside the luminaire.
If the flexible cable requires replacement, it should be replaced only by the Reggiani SpA Service Centre or by equivalent
qualified personnel in order to avoid hazards.
DALI
When programming DALI the two fluorescent lamps correspond to one address and each halogen lamps corresponds to one
address, while 3 addresses (each for one colour) correspond to LEDs RGB (i.e. one for red, one for green and one for blue).
It is not possible to control halide lamps by DALI
