Regency H2100, Инструкция для владельца и по установке

Страница: 11 / 24

Regency Wood Insert & Hearth Heater
11
installation
BricK flue Baffle &
secondarY air tuBe
installation
The flue baffle system located in the upper area
of the firebox is removable to make cleaning
your chimney system easier. The brick baffles
must be installed prior to your first fire. smoke
spillage and draft problems may occur if the
baffles are improperly positioned. Check the
position of the brick baffles on a regular basis as
they can be dislodged if too much fuel is forced
into the firebox.
The Large Insert I3100L is shipped with one of
the secondary air tubes loose inside the firebox.
It needs to be installed after the brick baffle are
installed. Follow the directions below.
large insert i3100l
The unit arrives with the third air tube (from the
front) and the 2 baffle bricks on the floor of the
firebox. The baffle bricks are positioned first and
then the air tubes are installed.
1)
Slide the left baffle brick over the two rear
air tubes and then push it all the way to the
left side of the firebox.
Front View
large insert (i3100l)
Hearth Heater (H2100M)
2) Tilt the first Baffle Brick down and then slide
the 2nd Baffle Brick up and back. Reposition
both baffle bricks flat on the air tubes.
3) important: push both baffle bricks so
they are tight against the side walls.
4)
Install the third air tube into the holes on the
side channels. The notch goes on the right
hand side with the air holes facing forward
toward the door opening. If the tube will not
slide in easily, simply use a pair of vise grips
or pliers and tap it into place with a hammer.
A tighter fit will ensure the tube will not move
when the unit is burning.
floor protection
Please check to ensure that your floor protection
and hearth will meet the standards for clearance
to combustibles. Your hearth extension must be
made from a non-combustible material.
fireBricK asseMBlY
Firebrick is included to extend the life of your
insert and radiate heat more evenly. Check to
see that all firebricks are in their correct posi-
tions and have not become misaligned during
door Handle
Attach spring handle by rotating counter clock-
wise onto rod. Ensure that the rod fits into the
entire length of the spring handle.
note: When cleaning the chimney reverse
the above procedures, removing
the air tube and baffle bricks and
then replace them when cleaning is
completed.