6
Regency Gosford Freestanding Wood Fire
INSTALLATION
1)
Please read this entire manual before you
install and use your new wood fi re. Failure
to follow instructions may result in property
damage, bodily injury or even death. Be
aware that local Codes and Regulations may
override some items in this manual. Check
with your local inspector.
2)
THE APPLIANCE AND FLUE-SYSTEM
SHALL BE INSTALLED IN ACCORDANCE
WITH AS/NZS 2918:2001 AND THE AP-
PROPRIATE REQUIREMENTS OF THE
RELEVANT BUILDING CODE OR CODES.
APPLIANCES INSTALLED IN ACCORD-
ANCE WITH THIS STANDARD SHALL
COMPLY WITH THE REQUIREMENTS OF
AS/NZS 4013 WHERE REQUIRED BY THE
REGULATORY AUTHORITY.
ANY MODIFICATION OF THE APPLIANCE
THAT HAS NOT BEEN APPROVED IN
WRITING BY THE TESTING AUTHORITY
IS CONSIDERED TO BE IN BREACH OF
THE APPROVAL GRANTED FOR COMPLI-
ANCE WITH AS/NZS 4013.
CAUTION: MIXING OF APPLIANCE OR
FLUE-SYSTEM COMPONENTS FROM
DIFFERENT SOURCES OR MODIFYING
THE DIMENSIONAL SPECIFICATION OF
COMPONENTS MAY RESULT IN HAZ-
ARDOUS CONDITIONS. WHERE SUCH
ACTION IS CONSIDERED, THE MANU-
FACTURER SHOULD BE CONSULTED
IN THE FIRST INSTANCE.
3)
Select a position for your Regency Stove.
Consult the minimum clearance chart for
your model and set the stove in place. For
close clearance installation use listed double
wall connector systems.
4)
To insure vertical alignment, suspend a plumb
bob from the ceiling over the exact center
of your stove fl ue and mark a spot on the
ceiling to indicate the center of the chimney.
5)
Check that the area above the ceiling is clear
for cutting. Re-confi rm the clearance from
the stove to combustibles to insure that they
are within the prescribed limits.
6)
Mark the location of the pedestal base on the
fl oor, then move the stove aside and mark
the position of the fl oor protector.
7)
Install chimney according to chimney manu-
facturers instructions. The performance of
your wood fi re is governed to a very large
part by the chimney system. Too short a
chimney can cause diffi cult start-up, dirty
glass, backsmoking when door is open, and
RESIDENTIAL
INSTALLATION
SAFETY GUIDELINES
AND WARNINGS
1)
Never use petrol, petrol type lantern fuels,
kerosene, charcoal lighter fuel, or similar
liquids to start or ‘freshen up’ a fi re in your
heater. Keep all such liquids well away from
the heater while it is in use.
2)
Keep the door closed during operation and
maintain all seals in good condition.
3)
Do not burn any quantities of paper, garbage,
and never burn fl ammable fl uids such as
petrol, naptha or engine oil in your stove.
4)
If you have smoke detectors, prevent smoke
spillage as this may set off a false alarm.
5)
Do not overfi re heater. If the chimney con-
nector, fl ue baffl e or the stove top begin to
glow, you are overfi ring. Stop adding fuel and
close the draft control. Overfi ring can cause
extensive damage to your stove including
warpage and premature steel corrosion.
Overfi ring will void your warranty.
6)
Do not permit creosote or soot build-up
in the chimney system. Check and clean
chimney at regular intervals. Failure to do
so can result in a serious chimney fi re.
7)
Your Regency stove can be very hot. You
may be seriously burned if you touch the
stove while it is operating, keep children,
clothing and furniture away. Warn children
of the burn hazard. For safety reasons a
guard around the fi re is recommended.
8)
The stove consumes air while operating,
provide adequate ventilation with an air
duct or open a window while the stove is in
use.
9)
Do not connect this unit to a chimney fl ue
serving another appliance.
10)
Do not use grates or andirons or other
methods for supporting fuel. Burn directly
on the base or bricks where supplied.
11)
Open the draft control fully for 10 to 15
seconds prior to slowly opening the door
when refuelling the fi re.
12)
Do not connect your unit to any air distribu-
tion duct.
13)
Your wood fi re should burn dry, standard
fi rewood only. The use of cut timber, ply-
wood, “mill ends”, etc. is not allowed as this
fuel can easily overheat your wood fi re.
Evidence of excessive overheating will void
your warranty. As well, a large portion of
sawmill waste is chemically treated timber,
which is illegal to burn in many areas. Salt
drift wood and chemically treated fi re logs
also must not be burned in your wood fi re.
14)
No combustible material should be closer
than the clearances as specifi ed on page
7.
15)
DO NOT OPERATE WITH BROKEN
GLASS.
even reduced heat output. Too tall a chimney
may prompt excessive draft which can re-
sult in very short burn times and excessive
heat output.
8)
The fl oor protector must be of non-com-
bustible material. Refer to page 7 for fl oor
protector clearances.
9)
When
the
fl oor protection is complete, posi-
tion the stove with the fl ue collar centered
under the installed chimney.
10)
In seismically active areas, Regency recom-
mends that your unit is secured to the fl oor
by using the bolt down holes inside the
pedestal.
11)
Do not connect this unit to a chimney
serving another appliance.
BRICK & CAST
INSTALLATION
Insert the rear cast plate fi rst and then the side
plates ensuring the cut out sections lock in fi rmly.
The bricks can then be placed on the base of the
fi rebox between the cast side and rear plates.
Firebrick is included to extend the life of your
stove and radiate heat more evenly.
Содержание F3000B
Страница 12: ...12 Regency Gosford Freestanding Wood Fire NOTES ...
Страница 13: ...Regency Gosford Freestanding Wood Fire 13 NOTES ...
Страница 14: ...14 Regency Gosford Freestanding Wood Fire NOTES ...
