Regal-Seton APPROX 4, Руководство пользователя

Страница: 6 / 10

- 6 -
10. bASE (Base) – Save or recall default settings
It is possible to store all the configurations of the unit into the storage device, and recall them
whenever required (this function can be really useful, if e.g. we use the unit often in the same
way).
To access to the menu press ENTER twice, while flashing warning sign can be seen on the
display.
-
In LOAd submenu pressing ENTER twice (flashing warning sign), the stored
configuration into the storage device overwrites all the actual settings.
Attention!!! Once the second ENTER has been pressed you lose all the actual settings.
- In SAUE (save) submenu pressing ENTER flashing sign warns that you are going to
overwrite the default configurations in the storage device. Overwriting can be carried out
by pressing UP and DOWN simultaneously.
Attention!!! The actual settings overwrite the default configuration, and you lose the
former configuration for good.
11. dISP (Display) – Set display’s brightness
Approx 4 offers the possibility to set the brightness of the display in 10 phase ( 0-9 ) at status
feedback. Entering the menu the horizontal lines at the place of the second character show the
brightness which can be reached with the given phase. To turn the display off choose phase
0 .
Independently of the phase chosen the menu and the error messages appear at full brightness.
12. t °C (Temperature) – Measure temperature
In the two main blocks of the unit temperature sensors are built in. Using this function ( ON )
Approx 4 displays the heat measured in both blocks every minute.
-
Exceeding 100 °C the measured value flashes on the display at full brightness.
- Exceeding 105 °C in any block the unit switches its channels off, cooling back under 100
°C it will switch the channels on automatically.
Avoiding heat protection ( OFF ) it is the operator’s responsibility to handle thermal problems
and consequences.
13. Conn (Connection) – Use of master/slave mode
Using the units without a lighting controller it is also possible to operate them simultaneously.
In
Conn menu one of the units can be decided to operate as a master unit ( MAS ) , the rest as
slave units ( SLAU ). So it is enough to set the chase and its parameters just in the master unit,
the others will do the same.
Choosing
Off master/slave can be switched off.
14. CHAS (Chase) – Edit or modify a Chase
Approx 4 has 9 preset, 3 logically editable and 1 level-memory (scale of 10%) editable
chases. Putting the unit in operation for the first time the editable chases are empty.